KTAG FW V7.020 SW V 2.23 Tech Support

---

K-tag firmware 7.020 Ksuite 2.23 Free download :
https://mega.nz/#!FsZjwIJL!dP50GTCaSXlqw3Ms3Dxut3VL1dR9VoLnpT1Mwb6HuQ8
(safe,no password)


Kess v2 master is possible to read Mercedes W211 the 2008 year with ECU Delphi DCM 3.2?

Perhaps not. Ktag should be a better choice to read Siemens/Delphi in BOOT mode.

ECU programming tools i have:Kess V2 + Ktag clone (buy as a kit,saved a lot)


With kess v2 master:

I tried it on my Ford Kuga from 2010: OK

i can read the ECU (just choosing the “Identification” option on the KSuite. The Ksuits shows me the info about the ECU, ok.

I tried it it on a Mercedes E220 W211 CDI 125kw (170 HP): Failed

the Kees V2 said to me: “Wake Up Error”.
I have read about this error and there are solutions about “Format the TF Card” inside or similar.

Note: This Kess V2 comes from a good and reliable seller, so maybe the problem is that this ECU cannot be read by OBd2
It is a second hand car, maybe the ecu it is already reprogrammed or similar.

This is the car list that i have:


I tried picking in another W211 models, but not works. Same error.


use this cable:


Read almost all the posts related to this topic. Now i confirmed problem is not kess. i have simens/delphi ecu, not edc16.

my engine bay:The car is from 2008… Facelift



This is the Right side :


The left side (viewing from driver):


The ECU is located under the A/C Filter. At the Left of the Hood.

See pictures:


It is a DELPHI like what i was told:



Engine sticker:


Siemens/Delphi can be done by Ktag programmer in boot mode.
It’sdelphi dcm 3.2 ecu.
Need BDM adapter an make a bridge for two pins.

This is what i found, about delphi dcm 3.2 ecu with a BDM100 programmer