tacho pro 2008 technical support
tacho-pro-2008-supported-vehicle-list.pdf (62K)
Here is the some question about this tacho pro. You can know this tacho pro better after reading these information.
Q: How to use this tacho pro to change the mileage? Any instruction?
A: There are 3 ways for this tacho pro to change the mileage: OBD diagnostic socket, remove dashboard and remove chip from the board. When you use this tacho pro to work on your car, after you choose the car model, it will prompt you to use which way and which cable. How to connect and so on. There is the user manual in the CD. Or you can follow the user manual to do.
Such as your car model is escalade 2002, when you connect this tool with your car, it will prompt you to fill in the clip number on chip EEprom 95020. Then click confirm. Then you can find this chip on your board then change the mileage in it.
Q: Can i update this tacho pro? Or does this tacho pro need to work together with computer?
A: Do not update it or connect this tacho pro with your computer to work. Otherwise this tacho pro will be locked, you need to send it back to us to repair. This tacho pro cannot updated. And it is worked alone. No need computer. When you start the device, do not press the update button.
Q: Password? What is the password for this tacho pro? Or does it need password when power on?
A: No, it does not need password.
How to Reprogram Mileage for Renault Avantime Using Tacho Pro 2008
Preparations:
912 Connector for Tacho Pro 2008 July device
Tacho Pro 2008 July PLUS Universal Dash Programmer
Follow step-by-step guide below to do:
1:Remove and disassemble the speedometer
2:Locate the processor
3:Solder the cable as the picture
4:Connect the plug 912 with the Tacho Pro Universal;
5: Select “speedometer” in the Tacho Universal;
6: The Tacho Universal shows you the old mileage data;
7: Enter the new mileage data;
8: Confirm the new mileage data with OK.
Note:
Speedometer and BSI have stood with the same miles when programmed.
How to Adjust Mileage for Toyota Corolla C46 with Tacho Pro U2008
How to read eeprom when adjust mileage with Tacho Pro U2008,Sincerely hope this will help friends with the same problems.
Car model and type:
Toyota Corolla, C46
Changing KM procedure:
Step1: Select car model: Corolla
Step2:Select car type: C46
Step3:Select function: Adjust KM
Step4: Cable connection as below
Notice:
What you have to try is check your cable correction.
Because your purpose is to change KM with odometer correction tool, you should select the function of “Adjust KM”, not “ Read EEPROM”.
