Ford VCM2 Firmware Update And Downgrade Manual


It's confirmed that Ford VCMII Firmware Update And Downgrade is possible, Operation steps guide here (This guide applies to all vcmii tools)
It's confirmed that Ford VCMII Firmware Update And Downgrade is possible
Procedure:
Remove the rubber case shown below.
Vcmii Firmware Update Downgrade 1
Connect the USB cable to the VCM2 device and hold the (ReSet) button shown as below.
Vcmii Firmware Update Downgrade 2
Connect the other end of the USB to a computer with IDS V86 installed, and then release the ReSet button until you hear a beep sound.
Vcmii Firmware Update Downgrade 3
Run Bosch\VCI Software(Ford-VCM-II)\VCI Manger(Ford-VCM-II).
Vcmii Firmware Update Downgrade 4
When you see the following image, it means you enter the recovery mode.
Vcmii Firmware Update Downgrade 5
After clicking on the “Recover” button, the program will switch to the VCMII Update interface.
Vcmii Firmware Update Downgrade 6
Click on “Start Update” to start the firmware update, and the following image will appear “Do not unplug the VCM II from the PC or remove power from the VCM II during the update process.”
Vcmii Firmware Update Downgrade 7
After clicking on “OK”, the following image will appear to start writing the new version of firmware.
Vcmii Firmware Update Downgrade 8
When the upgrade completed, the following prompt interface will appear, and the VCM II will automatically restart,wait until you hear the “beep”. Now exit VCM II Manager.
Vcmii Firmware Update Downgrade 9
Run the IDS. When the icon shown in the figure below appears, the VCM update is complete and it can be used normally.
Vcmii Firmware Update Downgrade 10
Enjoy!