How to use VVDI2 program Hyundai remote key
Using VVDI2 program Hyundai remote key step by step
Step 1 – chip information collection via
VVDI2 xhorse
Install the battery for the new wirless remote key
– take out the pcb on the remote controller
– install the battery
Generate wireless universal remote into chip signal collector via VVDI2 v1.2.2 software; VVDI2 automatically detect the chip
Press the remote control buttons and the LED will keep flashing (it means that: it’s coming into the collection status)
Signal acquisition is successful when the LED flashes rapidly
Information collection is complete. Now, ready for decoding and chip copy.
Put the chip with a battery installed into the remote control
Put the original car key into VVDI2 device for identification
Click on Start copy in VVDI2 interface
To collect information in the car and put the collector into VVDI2 (because we have been collecting data, it’s ok to put the collector into vvdi2)
Put the original key into vvdi2 key programmer again
Connect to the network, to begin decoding online
Chip decoding success!
Chip copy success
Step 3 – remote control generation
Try to start the car with the new copied key, after chip copy success
It can start the car but the remote cannot work properly
Ready to generate remote control
Use vvdi2 control generating function to generate the remote control
Put the new key into vvdi2 programmer
Finish vehicle info selection and click on Generate Remote Control
Complete
Use special equipment to program the remote
Xhorse wireless universal remote can copy a chip after regeneration as remote control, in the new equipment is the vvdi key tool (will add this function)
Done!
