OBDSTAR DC706 ECU Tool with TCM V30.09 can perform EEPROM/flash read and write operation on Hyundai ZF 6HP19 & 6HP26 (need OBDSTAR P003 Adapter), BOSCH TC60.X.X & TC80.X.X, and KEFICO CPGDSH2.2X.X TCM on bench. It's the same as Kia except 6HP19 and TC80.X.X.
| Brand | ECU Brand | Type | Read & write EEPROM | Read & write flash | Connection Method |
| HYUNDAI | ZF | 6HP19 | ✔ | BENCH+P003 | |
| HYUNDAI | ZF | 6HP26 | ✔ | BENCH+P003 | |
| HYUNDAI | BOSCH | TC60.X.X | ✔ | ✔ | BENCH |
| HYUNDAI | BOSCH | TC80.X.X | ✔ | ✔ | BENCH |
| HYUNDAI | KEFICO | CPGDSH2.2X.X | ✔ | ✔ | BENCH |
| KIA | ZF | 6HP26 | ✔ | BENCH+P003 | |
| KIA | BOSCH | TC60.X.X | ✔ | ✔ | BENCH |
| KIA | KEFICO | CPGDSH2.2X.X | ✔ | ✔ | BENCH |
Here takes TC60.X.X TCM as an example to show how to clone with DC706.
First, prepare all goods below.
Next, connect a power supply to DC706, and keep charging and communication during the operation.
Then, select ECU Flasher>> TCM>> TCM V30.09>> HYUNDAI BOSCH TC60.X.X TCM (BENCH), and complete the harness connection according to the Pinout.
A-Pin 2: 12 V (16)
A-Pin 3: 12V (16)
A-Pin 6: GND (4+5)
A-Pin 65: CAN L (14)
A-Pin 87: CAN H (6)
Connect P004 ECU Clone Jumper to TCM and P004 Adapter, then connect adapter to DC706 with the main cable.
After the harness is completed, click "Start" to enter the operation interface.
Connect to ECU (switch ignition off and turn on)
Read the original MAPS, INT EEPROM and INT Flash in sequence
Select the corresponding original data to write into a new TCM, all are successful.
Finally, switch the ignition off
Done!
OBDSTAR DC706 read and write Hyundai BOSCH TC60.X.X TCM by Bench
https://youtu.be/K5uJx4j2b8U
