Launch X431 ECU & TCU Programmer: Clone Bosch MED17.8.10 TC1728 ECM on Bench


Confirmed! Launch X431 ECU & TCU Programmer clone BOSCH MED17.8.10 TC1728 ECM on bench perfectly. No need X431 tablet! Easy operation with the wiring diagram in the software. Only 2 or 3 Minutes!

 

Here is the operation procedure.

1.Device connection

Connect X431 ECU Programmer to a computer via USB cable

Open X-431 ECU & TCU Programmer software

Input med17.8.10 in the search box to quickly find the ECU model

It's GreatWall Hover 62014-2018 TGI 1497 164 MED17.8.10 HW2_TC1728

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

Double click the ECU to enter the main operation interface

Obtain the wiring diagram by clicking "Direct connection of diagram"

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

Follow the diagram to connect X-431 ECU Programmer and Bosch MED17.8.10 ECM with the BENCH mode line properly

Connect the power supply to the programmer as well

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

Start to read and write ECU.

2.Read and write Bosch MED17.8.10 ECM

First, read chip ID

Next, read the original EEPROM data and save the data

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

Then, read the original FLASH data and save the data

Last, disconnect

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

After backup the original Bosch ECU data, use the same steps to read and save the new Bosch ECU.

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench
Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

Finally, upload the corresponding files to write into the new Bosch ECU

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

 

Wait a while until the operation is completed.

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench

Launch X431 ECU and TCU Programmer Clone Bosch MED17.8.10 TC1728 ECM on Bench
 

Alright! Launch X431 ECU Programmer clone MED17.8.10 ECU successfully.

LAUNCH X431 X-PROG3 with PC Adapter can perform this function as well.

www.obdexpress.co.uk