Super MB Pro M6 firmware update error 661 solution

Matched product:

SUPER MB PRO M6 DOIP Wireless Star Diagnosis Tool for Mercedes Benz Support Car Truck Bus MPV with LAN & OBD2 Cable

€380US$395^.20£326^.61AU$627^.30

• Item No. SP369-B
• Out Of Stock

1. Compatible with the original Mercedes software.
2. Support USB and WiFi wireless connection.
3. Support 12V car, 24V diesel truck bus, MPV etc.
4. Best replacement of MB SD C4/C5.

If you use Super MB Pro M6 to diagnose your vehicle, the software cannot connect to the car successfully, try to do self-test to check if the device issue or network cable is not connected properly, and update firmware. If you get the error DCDI_eErrorCode=661 (661) when updating firmware, you need to replace three files and change network configuration. Check the detailed solutions below.

1.Super MB Pro M6 hardware upgrade instructions:

(Applies to SD Connect C4/SD Connect C5)

• Path one：C:\Program Files\Mercedes-Benz\SDConnect Toolkit
• Path two：C:\Program Files\Softing\Diagnostic Tool Set 8\8.03\Interfaces\DCDI_DPduApi\eCOM_Toolkit
• Change the three file names of update_automaticx, update_manualx, and update_specialx under path one and path two to update_automatic, update_manual, and update_special (remove the letter x at the end of the file name). See figures below.

• After changing the file name, the computer restarts
• Not required to install 6 AA batteries
• OBD main cable should be connected to car or 12v power supply
• Right-click on the lower right corner of the computer to select administration, and then select Software update

• Mainly upgrade three files, as shown in the figure below, the upgrade sequence is 00——>02——>01——>03

2. Super MB Pro M6 Wireless MB Star error code 661 solution:

Step 1: Replace three files in the SDconnect Toolkit bin folder as below:

• exe
• dll
• dll

Note: Contact our customer service to get the replacement files.

Step 2: Change network connection configuration:

Go to Network and internet>> network connections>> vEthernet (Default switch)>> Networking>> Internet protocol version 4 (TCP/IIPV4) properties

Set IP address and DNS server address

Tick 'Use the following IP addresses'

IP address: 172.29.127.44

Subnet mask: 255.255.0.0

Tick 'Use the following DNS server addresses' and click 'OK'

For any question, please contact our customer service at:

E-mail: sales@OBDexpress.co.uk

Skype: obd2express.co.uk

WhatsApp: 0086-18750906257

www.obdexpress.co.uk